The user can adjust the heating temperature to 60 degree and there is one thermostat in every 12 meter heating.
Connection and function of auto thermostat:
The main part of heating system function is its thermostat. Its main principle is not only adjusting the heat volume that is emitting from itself turning on and off the heating system but also can remind the heating fluctuation level 0-10 degree to become the room always warm. Otherwise, it turns off when it reaches the temperature user adjusted and turns on automatically when heating is below the temperature it was reminded in it. For the thermostat, functioning like this way can save electricity usage by 50 %.
In addition, auto thermostat can be installed in every single room and the user can heat the object partially and save money.
The heating system can be controlled by GSM remote control without depending on the distance.
Role |
Note |
Main adjustment |
Range |
Explanation |
can differ cold and hot |
H-C |
HH |
HH CC |
HH –hot, CC- cold |
The lowest level of cold temperature |
t-L |
20 |
-20 -120 |
The lowest level of cold temperature of the heating system |
The highest level of hot temperature |
t-H |
80 |
-20 -120 |
The highest level of hot temperature of the heating system |
To measure difference of heating |
dlF |
1 |
1 -5 |
Can be on/off to eliminate the heating volume between thermostat and room. |
Time |
dLy |
20 |
1 сек-60 сек |
Can adjust on/off timing behind it |
Variance of constant heating |
OHt |
85 |
-20 - 120 |
It turns off if the heating volume exceeds from indicated volume. |
- The continuous line from thermostat is the line of heated volume exceeding and it can heat until your adjusted temperature, save electricity and is capable of saving heat volume without exceeding.
- The pecked line form thermostat is the line of constant heat. It can save the temperature for sometime after exceeding heat flux level and its break. It also can not cause the electrical overload.
- 2 lines above are 2 meter long separately and in order to install the heat center it is better to choose the place away from human reachable and should focus on the organization of the building.
- After the connection of thermostat, plug in A and check if there is any error in the heating system.
- 2 lines above are 2 meter long separately, if it is necessary it can be lengthened.